2138 Barton Hills Drive
00:00
Saved
Photo
First, establish scale so Designer can estimate physical lighting runs.
Use an independently known garage-opening width and its four corners, or use another existing measurement route.
Measurement Setup
Prepare the photo for accurate measurements
Calibrate the scale using a known reference such as a garage door or entry door, then establish the front and ridge baselines.
1
Calibrate ScaleSCALE · NOT READY
2
Front BaselineFRONT BASELINE · NOT READY
3
Ridge BaselineRIDGE BASELINE · NOT READY
MEASUREMENT SETUP INCOMPLETE
Scale · Scale not calibrated
Roof plane not ready · Measurement review required.
Is this ridge the same physical span as the front?
Measurement
Calibrate Roof Plane
Select a rectangular reference on one roof plane and enter its independently known width. Only horizontal spans on that plane are supported.
- 1Top leftCurrent
- 2Top rightNext
- 3Bottom rightNext
- 4Bottom leftNext
Click the top-left corner of the known rectangular roof-plane reference.
No image added for this view.
Measurement
Recalibrate Scale
For façade calibration, confirm the garage width and mark its four corners. Other references use two endpoints.
Current scale: not calibrated
18 ft
- 1Top leftCurrent
- 2Top rightNext
- 3Bottom rightNext
- 4Bottom leftNext
Click the first endpoint of the known reference.
Scale ready
18 ft reference
0 px measured
0 px / ft